Table 13: Show Ethernet Oam Lfm Status Output Fields - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

JUNOSe 11.1.x Link Layer Configuration Guide
Frame-seconds Error Monitor
Remote-loopback:
Table 13 on page 256 lists the show ethernet oam lfm status command output fields.
Meaning

Table 13: show ethernet oam lfm status Output Fields

256
Monitoring OAM Link-Fault Management Configuration for an Interface
Transmit-interval:
Loss-threshold:
Event Action:
High Threshold Action:
Remote-loopback:
Window:
Low threshold:
High threshold:
Frames sent:
Bytes sent:
Frames received:
Bytes received:
Field Name
Interface type/name
interfaceSpecifier
Mode
Transmit-interval
Loss-threshold
1000 ms
5 packets
disable
disable
supported
30 (100 millisecond units)
20 errored frames
none
104437
16167885
104437
16167885
Field Description
Name and type of the Ethernet interface, in the interface specifier
format, for which link-fault management packet details are
displayed
Discovery mode of the interface:
Active The interface discovers and monitors the peer on
the link if the peer also supports IEEE 802.3ah OAM
functionality. An OAM entity in active mode initiates the
discovery process by sending an Information OAM PDU to
the multicast address of the slow protocol (0180.c200.0002)
at a configured rate. The default discovery mode of the OAM
client is active
Passive An OAM entity does not initiate the discovery
process. You cannot perform link-fault management if you
configure both the local client and the remote peer for
passive mode operation
Number of milliseconds, after which Information OAM PDUs are
sent from the local OAM entity to the remote peer to maintain
the OAM association in an active state
Number of Information OAM PDUs that can be missed from the
remote peer before a link fault event is triggered