Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 57

Set the administrative state of an ATM AAL5 interface to disabled.
host1(config-if)#atm aal5 shutdown
Enable CAC on the interface.
host1(config-if)#atm cac 3000000 ubr 3000
Configure the clock source.
host1(config-if)#atm clock internal
Configure framing on a T3/E3 physical interface.
host1(config-if)#atm framing g751adm
Enable ILMI on the interface.
host1(config-if)#atm ilmi-enable
Set the ILMI keepalive timer.
host1(config-if)#atm ilmi-keepalive 5
Specify the cable length (line build-out) for the ATM interface.
host1(config-if)#atm lbo long
Set the administrative state of the ATM interface to disabled.
host1(config-if)#atm shutdown
Configure SNMP link status traps on the interface.
host1(config-if)#atm snmp trap link-status
host1(config-if)#atm aal5 snmp trap link-status
Set the operational mode of the physical interface to SDH STM1.
host1(config-if)#atm sonet stm-1
Configure the UNI version of ILMI using one of the following methods:
Enable auto configuration of ILMI.
host1(config-if)#atm auto-configuration
Set the UNI version that the router uses when ILMI link autodetermination
is unsuccessful or ILMI is disabled.
host1(config-if)#atm uni-version 4.0
Configure the number of virtual circuits for each virtual path.
host1(config-if)#atm vc-per-vp 128
Configure a virtual path tunnel and its traffic parameters.
Chapter 1: Configuring ATM
Setting Optional Parameters
25