Configuring A Dynamic Bridged Ethernet Interface; Figure 53: Dynamic Bridged Ethernet Over Static Atm 1483 Interface - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

JUNOSe 11.1.x Link Layer Configuration Guide
Figure 53: Dynamic Bridged Ethernet over Static ATM 1483 Interface Columns

Configuring a Dynamic Bridged Ethernet Interface

When you configure dynamic bridged Ethernet interfaces, you must assign a profile.
You may optionally assign a subscriber identification.
To configure dynamic bridged Ethernet interfaces:
1.
2.
3.
4.
558
Configuring Bridged Ethernet Dynamic Interfaces
Configure a physical interface.
host1(config)#interface atm 5/0
Configure an ATM subinterface.
host1(config-if)#interface atm 2/0.1
Configure a PVC by specifying the VCD, the VPI, the VCI, and the encapsulation
type.
If you want the router to autodetect the encapsulation type, use the
aal5autoconfig option.
host1(config-subif)#atm pvc 10 100 22 aal5snap
host1(config-subif)#atm pvc 10 100 22 aal5autoconfig
Do either of the following:
Configure the subinterface to detect and accept the dynamic bridged Ethernet
encapsulation type with the default lockout time range, 1–300 seconds.
host1(config-subif)#auto-configure bridgedEthernet
Configure the subinterface to detect and accept the dynamic bridged Ethernet
encapsulation type with a nondefault lockout time range. For example, the
following command configures 3600 seconds (1 hour) as the minimum
lockout time and 7200 seconds (2 hours) as the maximum lockout time.
host1(config-subif)#auto-configure bridgedEthernet lockout-time 3600 7200