Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 427

9.
10.
11.
encapsulation ppp
encapsulation vlan
ipv6 address
ipv6 nd
host1(config-if)#ipv6 unnumbered loopback 0
Enable the IPv6 Neighbor Discovery process on an interface.
host1(config-if)#ipv6 nd
Specify which IPv6 prefixes the system includes in IPv6 router advertisements.
host1(config-if)#ipv6 nd prefix-advertisement 2002:1::/64 60000 45000 onlink
autoconfig
(Optional) Configure additional VLAN subinterfaces by completing Steps 3 through
10.
Use to specify PPP as the encapsulation method for the interface.
Example
host1(config-if)#encapsulation ppp
Use the no version to disable PPP on an interface.
See encapsulation ppp.
Use to configure VLAN as the encapsulation method for the interface.
Example
host1(config-if)#encapsulation vlan
Use the no version to disable VLAN on an interface.
See encapsulation vlan.
Use to add an IPv6 address to an interface or a subinterface.
Example
host1(config)#interface gigabitEthernet 1/0.25
host1(config-if)#ipv6 address 1::1/64
Use the no version to remove an IPv6 address.
See ipv6 address
Chapter 12: Configuring Point-to-Point Protocol over Ethernet
Configuring PPPoE for Ethernet Modules
395