Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 769

remote loopback operation
halting
calculation and display of received data at
the prompt...............................................248
calculation and display of transmitted data
at the prompt...........................................248
viewing calculated loopback details.............248
prerequisite for enabling remote peer to loop back
PDUs...............................................................247
starting...............................................................247
stopping..............................................................247
remote loopback request
error message
if local entity is not placed in loopback
mode.......................................................247
if remote entity is not configured for
loopback..................................................247
Loopback control OAM PDU and........................240
placing the interface of remote peer in
loopback.........................................................240
received from the local entity
by the remote peer......................................240
remote OAM entity
prerequisite for enabling loopback operation
on...................................................................247
remote OAM peer
Ethernet OAM link-fault management and..........235
example scenario
for not building the OAM association...........235
intentional discard of data frames
when loopback is enabled...........................240
notifying forwarding state
to local OAM entity......................................240
preventing both local and remote entities
from simultaneous loopback........................240
receipt of Information PDUs
determination of OAM connection
establishment...........................................235
processing of configured rules on local entity
details......................................................235
supporting remote loopback
discarding locally sourced non-OAM
PDUs........................................................240
forwarding non-OAM PDUs to local
entity.......................................................240
round-robin packet distribution with MLPPP..............308
route interface command...........................................187
routing, configuring for transparent bridging.............486
RSTP (Rapid Spanning Tree Protocol).........................202
Ethernet link redundancy ...........................211, 218
S
S-VLANs (stacked virtual local area networks)
address possibilities............................................170
bridged Ethernet configurations..........................458
configuring PPPoE over S-VLAN..........................170
configuring to support dynamic PPPoE...............542
configuring tunnel interfaces
advantages..................................................184
example......................................................185
interface stacking........................................185
displaying status.................................................190
oversubscription.................................................188
overview.............................................................170
PPPoE over S-VLAN over bridged Ethernet.........460
scrambling ATM cell payload.......................................31
scripts
using to configure dynamic interfaces................598
SDH (Synchronous Digital Hierarchy).................363, 364
serial description command.......................................116
serial interfaces
configuring..........................116, 119, 277, 428, 508
Serial Line Address Resolution Protocol. See SLARP
service category, configuring for PVCs.........................48
service name tables, PPPoE. See PPPoE service name
tables
SFPs (small form-factor pluggable
transceivers)...................................................160, 163
short sequence number (SSN) header format.............304
show aaa commands
show aaa tunnel-parameters...............................420
show atm commands
show atm aal5 interface........................74, 599, 689
show atm atm1483...............................................74
show atm bulk-config..........................................690
show atm interface...............................................76
show atm map......................................................78
show atm oam......................................................78
show atm ping......................................................78
show atm subinterface..................86, 600, 619, 693
show atm vc.........................................92, 605, 699
show atm vc atm .................................................94
show atm vc-class.................................................99
show atm vp.........................................................99
show atm vp-description.......................................99
show atm vp-tunnel......................74, 104, 599, 689
show nbma arp...................................................105
show bridge commands
show bridge........................................................490
show bridge groups.............................................490
show bridge interface.........................................490
show bridge port.................................................490
show bridge table...............................................490
show bridge1483 interface command........................462
show columns command...................................607, 700
show frame-relay commands
show frame-relay interface.........................124, 140
show frame-relay lip...........................................140
show frame-relay lmi..................................124, 140
show frame-relay map................................124, 140
show frame-relay multilinkInterface...................140
Index
737
Index