Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 587

auto-configure
interface atm
aal5snap Specifies an LLC encapsulated circuit; LLC/SNAP header precedes
the protocol datagram.
aal5mux ip Specifies a VC multiplexed circuit. This option is used for IP
only.
Example
host1(config-subif)#atm pvc 6 0 11 aal5autoconfig
Use the no version to remove the specified PVC.
See atm pvc.
Use to configure an ATM subinterface to support a dynamic interface. Specifies
the types of dynamic encapsulation that the ATM 1483 subinterface detects and
accepts.
For detailed information about how to use this command, see "auto-configure"
on page 531.
Example 1 Enables autodetection for the IP encapsulation type using the default
lockout time range, 1–300 seconds
host1(config-subif)#auto-configure ip
Example 2 Enables autodetection for the IP encapsulation type using a
nondefault lockout time range, 3600–21600 seconds (1–6 hours)
host1(config-subif)#auto-configure ip lockout-time 3600 21600
Example 3 Disables encapsulation type lockout for the IP encapsulation type
host1(config-subif)#auto-configure ip lockout-time none
Example 4 Either command reenables encapsulation type lockout for the IP
encapsulation type using the default lockout time range
host1(config-subif)#auto-configure ip
host1(config-subif)#no auto-configure ip lockout-time
Example 5 Permanently locks out the IP encapsulation type until the
auto-configure ip command is issued
host1(config-subif)#no auto-configure ip
Use the no version to terminate detection of the specified encapsulation type
or, if the lockout-time keyword is specified, to restore the lockout time range
to its default value, 1–300 seconds.
See auto-configure.
Chapter 17: Configuring Dynamic Interfaces
Configuring IPoA Dynamic Interfaces
555