Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 452

JUNOSe 11.1.x Link Layer Configuration Guide
show aaa tunnel-parameters
show pppoe interface
420
Monitoring PPPoE
When baselining is requested, the time since the last baseline was set is displayed
in hours:minutes:seconds or days/hours format. If a baseline has not been set, the
message "No baseline has been set" is displayed instead.
Use the optional delta keyword with PPPoE show commands to specify that
baselined statistics will be shown.
Examples
host1#baseline pppoe interface atm 2/0.1.1
host1#baseline pppoe interface atm 2/0/0.1.1
There is no no version.
See baseline pppoe interface.
Use to display tunnel parameters that are configured for L2TP tunnel definitions,
including the calling number format.
Field descriptions
Tunnel password Default tunnel password
Tunnel client-name Hostname that the LAC sends to the LNS when
communicating about the tunnel
Tunnel nas-port-method Default NAS port type
Tunnel nas-port ignore Whether the router uses the tunnel peer's NAS-Port
[5] attribute; enabled or disabled
Tunnel nas-port-type ignore Whether the router uses the tunnel peer's
NAS-Port-Type [61] attribute; enabled or disabled
Tunnel assignmentID format Value of the tunnel assignment ID that is
passed to PPP/L2TP
Tunnel calling number format Format configured for L2TP Calling Number
AVP 22 generated by the LAC
Example
host1#show aaa tunnel-parameters
Tunnel password is 3&92k5b#q4
Tunnel client-name is host1
Tunnel nas-port-method is none
Tunnel nas-port ignore disabled
Tunnel nas-port-type ignore disabled
Tunnel assignmentId format is assignmentId
Tunnel calling number format is descriptive, includes agent-circuit-id
and
agent-remote-id
See show aaa tunnel-parameters.