Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 654

JUNOSe 11.1.x Link Layer Configuration Guide
622
Troubleshooting PPP and PPPoE Dynamic Interfaces
Example 1 Facilitates debugging for the ppp encapsulation type by swapping
profile pppConfig for profile pppLogConfig, which includes PPP packet–logging
attributes
host1#profile-reassign atm 2/0.101 ppp pppLogConfig
WARNING: Execution of this command will cause all dynamic interfaces over
atm 2/0.101 to be torn-down.
Proceed with profile reassignment? [confirm] yes
Profile pppConfig replaced by profile pppLogConfig for ppp.
Example 2 Facilitates debugging for the any encapsulation type by swapping
profile anyConfig for profile anyLogConfig, which includes both PPP and PPPoE
packet–logging attributes
host1#profile-reassign atm 3/0.101 any anyLogConfig
WARNING: Execution of this command will cause all dynamic interfaces over
atm 3/0.101 to be torn-down.
Proceed with profile reassignment? [confirm] yes
Profile anyConfig replaced by profile anyLogConfig for any.
Example 3 Restores the initial (nondebug) profile assignment for the ppp
encapsulation type shown in Example 1. Assuming that PPP packet logging is
not configured in profile pppConfig, this command also disables logging for the
interface
host1#profile-reassign atm 2/0.101 ppp pppConfig
WARNING: Execution of this command will cause all dynamic interfaces over
atm 2/0.101 to be torn-down.
Proceed with profile reassignment? [confirm] yes
Profile pppLogConfig replaced by profile pppConfig for ppp.
There is no no version.
See profile-reassign.