Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 730

JUNOSe 11.1.x Link Layer Configuration Guide
show atm vc
698
Monitoring Dynamic Interfaces and Profiles
BridgedEnet subscriber info
Username: elaine@jpeterman.com
Password: putty
Authenticate: enabled
SNMP trap link-status: disabled
InPackets:
InBytes:
OutPackets:
OutBytes:
InErrors:
OutErrors:
InPacketDiscards:
InPacketsUnknownProtocol: 0
OutDiscards:
1 interface(s) found
Example 5 Displays the current state of a specific ATM subinterface created
on the PVC with the specified VPI and VCI values
host1#show atm subinterface atm 0/0/0/101
Interface ATM-Prot VCD VPI VCI
----------- -------- --- --- --- ------- ----- ---- ------ ---------
ATM 0/0.101 RFC-1483 101
Auto configure status
Auto configure interface(s)
Detected 1483 encapsulation
Detected dynamic interface
Interface types in lockout
Lockout state (seconds)
------------------------------- --- --- ------- ------- ----
PPPoE
Assigned profile (IP)
Assigned profile (BridgedEnet): none assigned
Assigned profile (PPP)
Assigned profile (PPPoE)
Assigned profile (any)
SNMP trap link-status: disabled
InPackets:
InBytes:
OutPackets:
OutBytes:
InErrors:
OutErrors:
InPacketDiscards:
InPacketsUnknownProtocol: 0
OutDiscards:
1 interface(s) found
See show atm subinterface.
:
0
1904
0
0
0
0
14
0
Circuit
Type Encap MTU
0 101 PVC AUTO 9180 up
: dynamic
: PPPoE
: SNAP
: PPPoE
: none
: Min Max Current Elapsed Next
1 300 0
: none assigned
: none assigned
: pppoeprofile
: none assigned
5119
358672
5107
357510
0
0
3
0
Interface
Status Type
Static
0 1