Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 431

interface fastEthernet
interface gigabitEthernet
interface tenGigabitEthernet
ip address
pppoe
Use to select a Fast Ethernet interface.
For more information, see chapter Configuring Ethernet Interfaces in JUNOSe
Physical Layer Configuration Guide.
Example
host1(config)#interface fastEthernet 1/0
Use the no version to remove IP from an interface or subinterface. You must
issue the no version from the highest level down; you cannot remove an interface
or subinterface if the one above it still exists.
See interface fastEthernet.
Use to select a Gigabit Ethernet interface or a 10-Gigabit Ethernet interface.
To specify a Gigabit Ethernet interface for ERX7xx models, ERX14xx models,
and ERX310 router, use the slot/port[.subinterface ] format.
To specify a Gigabit Ethernet interface or 10-Gigabit Ethernet interface for E120
and E320 routers, use the slot/adapter/port[.subinterface ] format.
For more information, see chapter Configuring Ethernet Interfaces in JUNOSe
Physical Layer Configuration Guide.
Examples
host1(config)#interface gigabitEthernet 1/0
host1(config)#interface gigabitEthernet 4/0/1 6.0.0FRS
host1(config)#interface tenGigabitEthernet 4/0/1
Use the no version to remove IP from an interface. You must issue the no version
from the highest level down; you cannot remove an interface or subinterface if
the one above it still exists.
See interface gigabitEthernet.
See interface tenGigabitEthernet.
Use to assign an IP address and subnet mask to an interface or subinterface.
Example
host1(config-if)#ip address 192.1.1.1 255.255.255.0
Use the no version to remove an IP address or disable IP processing.
See ip address.
Chapter 12: Configuring Point-to-Point Protocol over Ethernet
Configuring PPPoE for Ethernet Modules
399