Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 584

JUNOSe 11.1.x Link Layer Configuration Guide
2.
pppoe clear lockout interface
552
Configuring PPPoE Dynamic Interfaces over PPPoE Static Interfaces
Total clients in active lockout: 0
Total clients in lockout grace period: 0
Client Address Current Elapsed Next
-------------- ------- ------- ----
0090.1a10.165e
To display the source MAC address when a subscriber is connected to the
router through an available PPPoE session, use either the show pppoe
interface lockout-time command or the show pppoe subinterface full
command. (The following example shows only the portion of the command
display relevant to the source MAC address.)
host1#show pppoe subinterface full
...
PPPoE subinterface ATM 3/0.101 has source MAC address 0090.1a10.165e
...
For a description of the fields in the command display, see "show pppoe interface
lockout-time" on page 608 and "show pppoe subinterface" on page 609.
Clear the current lockout condition for the PPPoE client associated with the
specified source MAC address on the static PPPoE major interface.
host1#pppoe clear lockout interface atm 3/0.101 0090.1a10.165e
If the specified PPPoE client is undergoing active lockout or is in a lockout grace
period, issuing the pppoe clear lockout interface command causes the router to
reset the current lockout condition and start the next lockout interval at the
minimum configured lockout time.
The lockout grace period occurs when the time between lockout events is greater
than either 15 minutes or the maximum lockout time. When a PPPoE client is
in a lockout grace period, the router resets the number of consecutive lockout
events to 1. (For more information, see "Guidelines for Configuring Encapsulation
Type Lockout" on page 527.)
Use to clear the lockout condition for the PPPoE client associated with the
specified source MAC address.
For PPPoE clients undergoing active lockout or in a lockout grace period, issuing
the pppoe clear lockout interface command causes the router to reset the current
lockout condition and start the next lockout interval at the minimum configured
lockout time.
You must specify the following:
interfaceType One of the following interface types listed in Interface Types
and Specifiers in JUNOSe Command Reference Guide:
atm
fastEthernet
gigabitEthernet
0 0 5