Configuring F5 Oam For Data Pvcs; Table 7: F5 Oam Configuration Tasks And Associated Commands - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

Configuring F5 OAM for Data PVCs

In ATM VC Configuration mode, you can use the individual commands listed in Table
7 on page 51 to configure nondefault values for F5 OAM services.

Table 7: F5 OAM Configuration Tasks and Associated Commands

For more information about OAM parameters, see "Operations, Administration, and
Management of ATM Interfaces" on page 15.
NOTE: The oam-ais rdi command and the oam retry command are available only
in ATM VC Configuration mode. There is no equivalent atm pvc command to configure
these F5 OAM alarm surveillance and VC integrity parameters.
For example, the following commands enable VC integrity on a data PVC with a
nondefault loopback frequency (30 seconds). Issuing the exit command causes the
configuration to take effect.
aal5mux ip Configures a VC-based multiplexed circuit used for IP only
aal5snap Configures an LLC encapsulated circuit; an LLC/SNAP header
precedes the protocol datagram; this is the default encapsulation method
You must issue the exit command from ATM VC Configuration mode for the
configuration to take effect.
Example
host1(config-subif-atm-vc)#encapsulation aal5mux ip
host1(config-subif-atm-vc)#exit
Use the no version to restore the default encapsulation method, aal5snap.
See encapsulation.
To Configure
Surveillance parameters for alarm indication
signal (AIS) and remote defect indication (RDI)
fault management cells
Continuity check (CC) verification
Generation of F5 loopback cells and enabling
of VC integrity
Parameters for VC integrity
host1(config)#interface atm 3/0.0
host1(config-subif)#pvc 32 0/32
host1(config-subif-atm-vc)#oam-pvc manage 30
Chapter 1: Configuring ATM
Use This Command
oam ais-rdi
oam cc
oam-pvc
oam retry
Configuring Individual ATM PVC Parameters
51