Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 514

JUNOSe 11.1.x Link Layer Configuration Guide
NOTE: You cannot change the default subscriber policy values for a trunk (server)
bridge interface. As a result, you cannot use the bridge subscriber-policy command
to associate a nondefault subscriber policy with a trunk bridge interface.
broadcast
ip
mpls
482
Configuration Tasks
host1(config)#bridge westford02 subscriber-policy client01
Use the no version to remove the association with the subscriber policy.
See bridge subscriber-policy.
Use to modify the subscriber policy for the broadcast protocol to define whether
a subscriber (client) bridge interface permits (forwards) or denies (filters or drops)
broadcast packets.
Specify one of the following keywords:
permit Forwards packets of this type
deny Filters or drops packets of this type
Broadcast packets are filtered or dropped by default.
Example
host1(config-policy)#broadcast permit
Use the no version to restore the default value.
See broadcast.
Use to modify the subscriber policy for IP to define whether a subscriber (client)
bridge interface permits (forwards) or denies (filters or drops) IP packets.
Specify one of the following keywords:
permit Forwards packets of this type
deny Filters or drops packets of this type
IP packets are forwarded by default.
Example
host1(config-policy)#ip deny
Use the no version to restore the default value.
See ip.