Configuring A Ppp Or Pppoe Dynamic Interface; Figure 45: Dynamic Ppp Interface Columns; Figure 46: Dynamic Pppoe Interface Columns - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

Chapter 17: Configuring Dynamic Interfaces

Figure 45: Dynamic PPP Interface Columns

Figure 46 on page 529 shows dynamic PPPoE interface columns and illustrates how
PPPoE supports multiple IP sessions over each ATM 1483 circuit.

Figure 46: Dynamic PPPoE Interface Columns

You can specify either or both ppp and pppoe for the interface by specifying the
auto-configure command for each type of interface. The first packet received defines
the type of dynamic interface that is created.

Configuring a PPP or PPPoE Dynamic Interface

To configure an ATM 1483 subinterface to support a PPP or PPPoE dynamic interface:
529
Configuring PPP and PPPoE Dynamic Interfaces over Static ATM