Figure 51: Dynamic Pppoe Over Static Pppoe With S-Vlan Interface - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

Figure 51: Dynamic PPPoE over Static PPPoE with S-VLAN Interface Columns
To configure an S-VLAN subinterface to support a dynamic PPPoE subinterface:
Specify a Fast Ethernet, Gigabit Ethernet, or 10-Gigabit Ethernet interface.
1.
host1(config)#interface fastEthernet 4/1
Specify VLAN as the encapsulation method.
2.
host1(config-if)#encapsulation vlan
This command creates the VLAN major interface.
Create a VLAN subinterface by adding a subinterface number to the interface
3.
identifier.
host1(config-if)#interface fastEthernet 3/1.1
Assign an S-VLAN ID and a VLAN ID for the subinterface.
4.
host1(config-if)#svlan id 3 300
Assign an S-VLAN Ethertype.
5.
host1(config-if)#svlan ethertype 9200
Specify PPPoE as the encapsulation method on the interface.
6.
host1(config-subif)#encapsulation pppoe
This command creates the PPPoE major interface.
Assign a profile.
7.
host1(config-subif)#pppoe profile pppoeProfile3
Configuring PPPoE Dynamic Interfaces over PPPoE Static Interfaces
Chapter 17: Configuring Dynamic Interfaces
543