Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 321

For e series broadband services routers - link layer configuration
Table of Contents

Advertisement

max-negotiations Maximum number of renegotiation attempts that
the router accepts before terminating a PPP session
ipcp prompt-option dns Prompts the CPE (Customer Premises
Equipment) to negotiate the IPCP primary and secondary DNS options
that are locally available with the broadband remote access server
(enabled or disabled)
IPV6CP protocol configuration
configured IPv6CP is configured on this interface (true or false)
administrative-status IPv6CP administrative status (open or closed)
ipv6-interfaceId Address to be used for negotiation of local IPv6 address
option
IPCP protocol status
operational-status IPCP operational status (up, down, not present, or
not present no resources)
terminate-reason Reason for termination of IPCP service
IPV6CP protocol status
operational-status IPv6CP operational status (up, down, not present,
or not present no resources)
terminate-reason Reason for termination of IPv6CP service
IPCP negotiated options Shows the following negotiated addresses for the
local and remote (peer) side of the link
ip-address IP address
ip-address-mask IP address mask
primary-dns-address Primary DNS address
secondary-dns-address Secondary DNS address
primary-wins-address Primary WINS address
secondary-wins-address Secondary WINS address
NOTE: The command displays a value of "none" for any negotiated option parameters
if the option was not negotiated.
OSINLCP protocol configuration
configured OSINLCP is configured on this interface (true or false)
administrative-status OSINLCP administrative status (open or closed)
OSINLCP protocol status
Chapter 8: Configuring Point-to-Point Protocol
Monitoring PPP Interfaces
289

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.1.x

Table of Contents