Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 92

For e series broadband services routers - link layer configuration
Table of Contents

Advertisement

JUNOSe 11.1.x Link Layer Configuration Guide
In dsl-subscriber-class:
To configure an ATM VC class with systemwide default values, you can issue the
vc-class atm command followed immediately by the exit command. For example,
the following commands create a VC class named default-vc-class. Because no attribute
values are explicitly specified in default-vc-class, the router applies the default values
for the commands listed in Table 8 on page 59. For information about the default
value for each command, see the command descriptions in this section.
To verify the VC class configuration, use the show atm vc-class command. For
information about how to use this command, see "show atm vc-class" on page 99.
cbr
encapsulation
60
Configuring ATM VC Classes
The oam-pvc command enables generation of F5 OAM loopback cells and F5
OAM VC integrity.
The oam ais-rdi command configures the alarm down count for successive AIS
and RDI alarm cells to 5.
The encapsulation command sets the encapsulation method to aal5autoconfig.
The ubr command configures the UBR service category without a PCR.
! Configure VC class with default values.
host1(config)#vc-class atm default-subscriber-class
host1(config-vc-class)#exit
host1(config)#
Use to configure the CBR service category on an ATM data PVC.
For detailed information about how to use this command, see "cbr" on page 48.
You must issue the exit command from ATM VC Class Configuration mode for
the configuration to take effect.
Example
host1(config-vc-class)#cbr 15000
host1(config-vc-class)#exit
Use the no version to restore the default service category, UBR without a PCR.
See cbr.
Use to configure the encapsulation method on an ATM data PVC.
For detailed information about how to use this command, see "encapsulation"
on page 50.
You must issue the exit command from ATM VC Class Configuration mode for
the configuration to take effect.
Example
host1(config-vc-class)#encapsulation aal5mux ip
host1(config-vc-class)#exit

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.1.x

Table of Contents