Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 73

atm pvc
interface atm
ip atm-vc
map-group
Use to configure a PVC on an ATM interface.
InARP and refresh rate are optional parameters.
InARP determines whether InARP requests are used and is specified on a
per-circuit basis. If you disable InARP, you must use a static map table entry.
Transmission over the circuit cannot occur unless you use either InARP or static
map table entries.
The default refresh rate is 15 minutes.
You can configure InARP only if you specify the aal5snap encapsulation type.
Example
host1(config-if)#atm pvc 6 0 11 aal5snap inarp 10
Use the no version to remove the specified PVC.
See atm pvc.
Use to configure an ATM interface or subinterface type.
For information about specifying the ATM interface or subinterface, see "interface
atm" on page 24.
Specify multipoint to identify the subinterface as NBMA.
Examples
host1(config-if)#interface atm 0/1.20
host1(config-if)#interface atm 0/0/4.20
Use the no version to remove the subinterface or the logical interface.
See interface atm.
Use to associate a protocol and address with a specific virtual circuit.
Use this command repeatedly for each circuit to be mapped.
This command is available in Map List Configuration mode only.
Example
host1(config-map-list)#ip 192.168.13.13 atm-vc 1 broadcast
Use the no version to remove the association.
See ip atm-vc.
Chapter 1: Configuring ATM
Creating an NBMA Static Map
41