Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 111

host1#show atm interface atm 2/0
ATM Interface 2/0 is down, line protocol is down
AAL5 operational status:
time since last status change: 22:08:21
ATM operational status:
time since last status change: 22:02:11
SONET path operational status: lowerLayerDown
time since last status change: 1 day, 0 hours
SONET operational status:
time since last status change: 1 day, 0 hours
UNI version: 3.0, Maximum VCs: 4096
Current VCs: 1
ILMI VPI/VCI: 17/23, VCD 26, ILMI keepalive: disabled
Max VCI per VPI: 32768
CAC admin state: enabled
Subscription bandwidth: 3000000 kbps
UBR weight: 3000 kbps
Available bandwidth: 2992000 kbps
SNMP trap link-status: enabled
OAM cell receive status: enabled
OAM cell filter : all cells
atm oam loopback-location 0XFFFFFFFF
Interface Alias: ATM interface slot #2 port 0
Assigned VC class
PHY Type: oc3, Framing: sonet, TX clocking: line
Loopback: none, Receive FIFO Overruns: 0
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
InPackets: 0
InBytes: 0
InCells: 0
OutPackets: 0
OutBytes: 0
OutCells: 0
InErrors: 0
OutErrors: 0
InPacketDiscards: 0
InByteDiscards: 0
InCellErrors: 0
qos-mode-port disabled
queue 0: traffic class control, bound to ATM2/0
Forwarded packets 643, Bytes 36008
Dropped committed packets 0, Bytes 0
Dropped conformed packets 0, Bytes 0
Dropped exceeded packets 0, Bytes 0
Example 2 Shows a summary of all ATM interfaces
host1#show atm interface brief
Interface Status
--------- --------------
ATM 2/0 up
ATM 2/1 up
ATM 2/2 lowerLayerDown
ATM 2/3 down
lowerLayerDown
down
down
: dsl-subscriber-class
Configured
VCs
----------
2
3
4
5
Chapter 1: Configuring ATM
79
Monitoring ATM