Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 449

radius override calling-station-id remote-circuit-id
radius override nas-port-id remote-circuit-id
radius remote-circuit-id-delimiter
Use to enable a static PPPoE interface (from Interface Configuration mode or
Subinterface Configuration mode) or a dynamic PPPoE interface (from Profile
Configuration mode) to capture and process a vendor-specific tag containing a
remote circuit ID transmitted from a DSLAM.
The router can then send this value to a RADIUS server or to an L2TP network
server (LNS) to uniquely identify subscriber locations.
Examples
host1(config-if)#pppoe remote-circuit-id
host1(config-profile)#pppoe remote-circuit-id
Use the no version to restore the default behavior, which is not to capture and
process the PPPoE remote circuit ID.
See pppoe remote-circuit-id.
Use to configure RADIUS to override the standard use of the Calling-Station-Id
[31] RADIUS attribute and instead use the PPPoE remote circuit ID transmitted
from a DSLAM.
Example
host1(config)#radius override calling-station-id remote-circuit-id
Use the no version to restore the default Calling-Station-Id value, which is the
telephone number from which the call originated.
See radius override calling-station-id remote-circuit-id.
Use to configure RADIUS to override the standard use of the NAS-Port-Id [87]
RADIUS attribute and instead use the PPPoE remote circuit ID transmitted from
a DSLAM.
Example
host1(config)#radius override nas-port-id remote-circuit-id
Use the no version to restore the default NAS-Port-Id value, which is the physical
interface of the network access server (NAS) that is authenticating the user.
See radius override nas-port-id remote-circuit-id.
Use to configure the delimiter character that the router uses to set off multiple
components in the format of the PPPoE remote circuit ID value captured from
a DSLAM.
Example
host1(config)#radius remote-circuit-id-delimiter !
Chapter 12: Configuring Point-to-Point Protocol over Ethernet
Configuring PPPoE Remote Circuit ID Capture
417