Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 443

4.
5.
6.
7.
atm pvc
auto-configure
interface atm
Configure a physical interface.
On ERX7xx models, ERX14xx models, and the ERX310 router:
host1(config-if)#interface atm 3/0.1
Configure an ATM PVC by specifying the VCD, the VPI, the VCI, and the
encapsulation type.
host1(config-subif)#atm pvc 10 100 22 aal5snap
Apply the profile to the interface.
host1(config-subif)#profile pppoe baseProfile
Enable the PPPoE dynamic encapsulation type.
host1(config-subif)#auto-configure pppoe
Use to configure a PVC on an ATM interface.
For details about specifying the mandatory VCD, VPI, VCI, and encapsulation
type parameters, see "atm pvc" on page 389.
Example
host1(config-if)#atm pvc 10 100 22 aal5snap
Use the no version to remove the specified PVC.
See atm pvc.
Use to configure an ATM 1483 subinterface to support a dynamic interface.
Specifies the type(s) of dynamic encapsulation that will be accepted/detected by
the ATM 1483 subinterface.
This command causes the layers above ATM 1483 to become dynamic.
Select pppoe as the dynamic next upper interface type.
Example
host1(config-subif)#auto-configure pppoe
Use the no version to disable detection of the specified encapsulation.
See auto-configure.
Use to configure an ATM interface.
For information about specifying the ATM interface or subinterface, see "interface
atm" on page 390.
Examples
Chapter 12: Configuring Point-to-Point Protocol over Ethernet
Configuring PPPoE Service Name Tables
411