Table of Contents
Advertisement
JUNOSe 11.1.x Link Layer Configuration Guide
radius remote-circuit-id-format
418
Configuring PPPoE Remote Circuit ID Capture
Use the no version to restore the default delimiter character, #.
See radius remote-circuit-id-delimiter.
Use to configure the format of the PPPoE remote circuit ID value captured from
a DSLAM.
By default, the router formats the PPPoE remote circuit ID to include only the
agent-circuit-id suboption (suboption 1) of the tags supplied by the PPPoE
intermediate agent.
You can use this command to configure one of the following nondefault formats
for the PPPoE remote circuit ID value:
To include the agent-circuit-id suboption, use the agent-circuit-id keyword.
To include the agent-remote-id suboption (suboption 2) of the tags supplied
by the PPPoE intermediate agent, use the agent-remote-id keyword.
To include the NAS-Identifier [32] RADIUS attribute, use the nas-identifier
keyword. If you include the nas-identifier keyword, you must also include
either or both of the agent-circuit-id and agent-remote-id keywords.
To append the agent-circuit-ID value to an interface specifier that is consistent
with the recommended format in DSL Forum Technical Report
(TR)-101 Migration to Ethernet-Based DSL Aggregation (April 2006)the ,
use the dsl-forum-1 keyword. For details about how the router implements
this format, see "Format for dsl-forum-1 Keyword" on page 381.
RADIUS overrides the standard use of the Calling-Station-Id [31] or NAS-Port-Id
[87] attribute with the PPPoE remote circuit ID only if the DSLAM transmits
non-empty data for at least one of the agent-circuit-id or agent-remote-id values.
If the DSLAM transmits empty data, then RADIUS does not override the
Calling-Station-Id [31] or NAS-Port-Id [87] RADIUS attribute with the PPPoE
remote circuit ID and instead uses the standard value for the RADIUS attribute.
If a single component in a multi-component PPPoE remote circuit ID format is
empty, the router represents the empty component as two consecutive delimiter
characters (## by default).
Example 1 Formats the PPPoE remote circuit ID value to include only the
agent-remote-id suboption of the tags supplied by the PPPoE intermediate agent.
host1(config)#radius remote-circuit-id-format agent-remote-id
Example 2 Formats the PPPoE remote circuit ID value to include both the
agent-circuit-id and agent-remote-id suboptions of the tags supplied by the PPPoE
intermediate agent.
host1(config)#radius remote-circuit-id-format agent-circuit-id agent-remote-id
Example 3 Formats the PPPoE remote circuit ID value to include the
NAS-Identifier [32] RADIUS attribute with the agent-circuit-id suboption of the
tags supplied by the PPPoE intermediate agent.
host1(config)#radius remote-circuit-id-format nas-identifier agent-circuit-id
Advertisement
Table of Contents
Troubleshooting
