Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 440

JUNOSe 11.1.x Link Layer Configuration Guide
atm pvc
encapsulation pppoe
interface atm
pppoe service-name-table
408
Configuring PPPoE Service Name Tables
Use to configure a PVC on an ATM interface.
For details about specifying the mandatory VCD, VPI, VCI, and encapsulation
type parameters, see "atm pvc" on page 389.
Example
host1(config-if)#atm pvc 10 100 22 aal5snap
Use the no version to remove the specified PVC.
See atm pvc.
Use to specify PPPoE as the encapsulation method for the interface.
This command creates a PPPoE major interface.
Example
host1(config-subif)#encapsulation pppoe
Use the no version to disable PPPoE on an interface.
See encapsulation pppoe.
Use to configure an ATM interface.
For information about specifying the ATM interface or subinterface, see "interface
atm" on page 390.
Examples
host1(config)#interface atm 3/1.19
host1(config)#interface atm 3/0/1.19
Use the no version to remove the interface or subinterface.
See interface atm.
Use from Subinterface Configuration mode to assign a PPPoE service name table
to a PPPoE major interface for use by a static ATM 1483 subinterface.
Specify the name of the PPPoE service name table configured with the
pppoe-service-name-table command from Global Configuration mode.
Example
host1(config-subif)#pppoe service-name-table myServiceTable1
Use the no version to remove the PPPoE service name table assignment.
See pppoe service-name-table.