JUNOSe 11.1.x Link Layer Configuration Guide
ipv6 address
ipv6 nd
ipv6 unnumbered
540
Configuring PPPoE Dynamic Interfaces over PPPoE Static Interfaces
Use to assign a virtual router to a profile.
You can configure a virtual router using RADIUS instead of adding one to the
profile by using the ip virtual-router command. For more information about
how to configure a virtual router using RADIUS, see Configuring RADIUS Attributes
in the JUNOSe Broadband Access Configuration Guide.
Example
host1(config-profile)#ip virtual-router VR1
Use the no version to remove the virtual router assignment.
See ip virtual-router
Use to add an IPv6 address to an interface or a subinterface.
Example
host1(config)#interface gigabitEthernet 1/0.25
host1(config-if)#ipv6 address 1::1/64
Use the no version to remove an IPv6 address.
See ipv6 address
Use to enable the IPv6 Neighbor Discovery process on an interface.
You can include the following commands in IPv6 profiles to configure Neighbor
Discovery route advertisement characteristics.
Command
ipv6 nd
ipv6 nd other-config-flag
ipv6 nd ra-interval
Example
host1(config)#profile ProfileIpv6South22
host1(config-profile)#ipv6 nd
Use the no version to disable the Neighbor Discovery process for the profile.
See ipv6 nd
Description
Enables Neighbor Discovery on an interface
Sets the "other stateful configuration" flag in IPv6 router
advertisements
Configures the interval between IPv6 router advertisements