Troubleshooting - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

JUNOSe 11.1.x Link Layer Configuration Guide
show radius remote-circuit-id-format

Troubleshooting

Use the pppoeControlPacket log to diagnose problems on your PPPoE interfaces.
log severity debug pppoeControlPacket
434
Troubleshooting
Use to display the delimiter character configured to set off components in the
PPPoE remote circuit ID value captured from a DSLAM.
The default delimiter character is #.
Example
host1#show radius remote-circuit-id-delimiter
%
See show radius remote-circuit-id-delimiter.
Use to display the format configured for the PPPoE remote circuit ID value
captured from a DSLAM.
If the PPPoE remote circuit ID value is configured to include any or all of the
agent-circuit-id, agent-remote-id, and nas-identifier components, the display lists
the components included and the order in which they appear.
If the PPPoE remote circuit ID value is configured to use the format for the
dsl-forum-1 keyword of "radius remote-circuit-id-format" on page 418 , the display
indicates that this format is in effect.
The default format is agent-circuit-ID.
Example
host1#show radius remote-circuit-id-format
nas-identifier agent-circuit-id agent-remote-id
See show radius remote-circuit-id-format.
Use to configure a packet trace log for a PPPoE interface. You must specify a
PPPoE major interface.
Specify one of the following interface types and a corresponding interface
specifier. For more information, see Interface Types and Specifiers in JUNOSe
Command Reference Guide.
fastEthernet
gigabitEthernet
atm
tenGigabitEthernet
The packet trace log for a PPPoE interface displays only the first 256 bytes of
packet data. Data in excess of 256 bytes does not appear in the packet trace log.