Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 641

For e series broadband services routers - link layer configuration
Table of Contents

Advertisement

show pppoe subinterface
show profile
Elapsed Time elapsed into the lockout time, in seconds; displays 0 (zero)
if the PPPoE client is not undergoing lockout
Next Lockout time that the router uses for the next lockout event, in seconds
Example
host1#show pppoe interface atm 3/0.101 lockout-time
PPPoE interface ATM 3/0.101
Lockout Configuration (seconds): Min 5, Max 60
Total clients in active lockout: 0
Total clients in lockout grace period: 0
Client Address Current Elapsed Next
-------------- ------- ------- ----
0090.1a10.165e
See show pppoe interface lockout-time.
Use to display the source MAC address of a PPPoE client when a subscriber is
connected to the router through an available PPPoE session. You can then specify
this MAC address in "pppoe clear lockout interface" on page 552 to clear the
lockout condition for the PPPoE client.
To display configuration, status, and statistics information, including the source
MAC address of the PPPoE client, use the full keyword.
The following field descriptions and example include only the portion of the
show pppoe subinterface command display relevant to the source MAC address
for PPPoE clients. For more information about using this command, see "show
pppoe subinterface" on page 428 in "Configuring Point-to-Point Protocol over
Ethernet" on page 375.
Field descriptions
PPPoE subinterface Specifier for the PPPoE subinterface
source MAC address MAC address of the PPPoE client associated with the
dynamic PPPoE subinterface column
Example
host1#show pppoe subinterface full
...
PPPoE subinterface ATM 3/0.101 has source MAC address 0090.1a10.165e
...
See show pppoe subinterface.
Use to display information about profiles.
To display information about a specific profile, use the name keyword.
To display a list of profiles configured on the router, use the brief keyword.
Field descriptions
Monitoring Upper-Layer Dynamic Interfaces and Profiles
Chapter 17: Configuring Dynamic Interfaces
0
0
5
609

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.1.x

Table of Contents