Monitoring 802.3Ad Link Aggregation - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

JUNOSe 11.1.x Link Layer Configuration Guide

Monitoring 802.3ad Link Aggregation

This section explains how to use the show commands to display the characteristics
and the configured settings for 802.3ad link aggregation.
NOTE: The E120 and E320 routers output for monitor and show commands is
identical to output from other E Series routers, except that the E120 and E320 routers
output also includes information about the adapter identifier in the interface specifier
(slot/adapter/port).
show interfaces lag
222
Monitoring 802.3ad Link Aggregation
host1(config-if)#redundant-port gigabitEthernet 4/0 force-failover
There is no no version.
See redundant-port force-failover.
Use to display information about a specified Ethernet member link in an IEEE
802.3ad link aggregation group (LAG) bundle.
Specify either the Fast Ethernet or Gigabit Ethernet interface type when issuing
this command:
host1#show interfaces interfaceType interfaceSpecifier lag
Field descriptions
interfaceSpecifier Status of the hardware on this interface
Up Hardware is operational
Down Hardware is not operational
Administrative status Operational state that you configured for this interface
Member Membership status of the Ethernet link
LACP Status of LACP configuration for the Ethernet link
active Ethernet link participates in the protocol regardless of whether
its Partner member link is set to active or passive LACP PDU participation
passive Ethernet link transmits LACP PDUs only when it receives LACP
PDUs from its Partner member link
mux state Status of collecting and distributing at the Mux state machine
collecting/distributing Ethernet link is actively collecting incoming
frames and distributing outgoing frames
detached Ethernet link is detached from the LAG bundle due to protocol
changes or system constraints
waiting Ethernet link is waiting to attach to a LAG bundle