Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 607

ip virtual-router
ipv6 address
ipv6 http
ipv6 http redirectUrl
Use to assign a virtual router (VR) to a profile. Interfaces created by the profile
are attached to this VR.
If the VR specified in a profile with the ip virtual-router command differs from
the VR provided by AAA, IP uses the VR provided by AAA when the dynamic IP
upper-layer interface is created. For more information about using the ppp
authentication virtual-router command, see "ppp authentication" on page 580.
Example
host1(config-profile)#ip virtual-router salem1
Use the no version to remove the VR assignment from the profile. If no VR is
specified via RADIUS, then any subsequent use of the profile to create a dynamic
interface fails for lack of a VR.
See ip virtual-router
Use to configure an IPv6 address on an interface to which the profile is attached.
Example
host1(config-profile)#ipv6 address 1::1/64
Use the no version to remove the IPv6 address from the interface.
See ipv6 address.
Use to create the HTTP local server to listen and process for IPv6 exception
packets.
See Configuring the HTTP Server to Support Guided Entrance in the JUNOSe
Broadband Access Configuration Guide
Example
host1(config)#ipv6 http
Use the no version to delete the HTTP local server.
See ipv6 http.
Use to specify the URL to which a subscriber's HTTP access session is redirected.
The first access session is typically used by the Service Manager application to
provide initial provisioning and service selection for the subscriber.
HTTP redirect is per-interface; use the command in Interface, Subinterface or
Profile Configuration mode for static interfaces.
The redirect URL can be a maximum of 64 characters.
Chapter 17: Configuring Dynamic Interfaces
Configuring a Dynamic Interface from a Profile
575