Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 527

Subscriber Policy Name of the subscriber policy currently in effect for
the bridge group interface
In Octets Number of octets received on this interface
In Frames Number of frames received on this interface
In Discards Number of incoming packets discarded on this interface
In Errors Number of incoming errors received on this interface
Out Octets Number of octets transmitted on this interface
Out Frames Number of frames transmitted on this interface
Out Discards Number of outgoing packets discarded on this interface
Out Errors Number of outgoing errors on this interface
queue Hardware packet queue associated with the specified traffic
class and interface
Queue length Length of the queue, in bytes
Forwarded packets, Bytes Number of packets and bytes forwarded on
this queue
Dropped committed packets, Bytes Number of committed packets and
bytes that were dropped
Dropped conformed packets, Bytes Number of conformed packets and
bytes that were dropped
Dropped exceeded packets, Bytes Number of exceeded packets and
bytes that were dropped
Example 1 Displays configuration settings for the specified bridge group
host1#show bridge westford01
BridgeGroup: westford01
Bridge Mode:
Aging Time:
Learning:
Max Learn:
Link Status Snmp Traps: Disabled
Subscriber Policy:
Protocol Actions:
Route IP
Route PPPoE
Port Count:
Interface Count:
Example 2 Displays information about configuration settings, MAC address
table entries, and bridge group interfaces for the specified bridge group
host1#show bridge westford01 all
BridgeGroup: westford01
Bridge Mode:
Aging Time:
Chapter 15: Configuring Transparent Bridging
CRB
300 secs
Enabled
Unlimited
default Subscriber
1
1
CRB
300 secs
Monitoring Transparent Bridging
495