Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 61

atm framing
atm ilmi-enable
atm ilmi-keepalive
module Internal clock is from the line module (the default)
chassis Internal clock is from the configured system clock
Example
host1(config-if)#atm clock internal
Use the no version to cause ATM interfaces to recover the clock from the received
signal.
See atm clock internal.
Use to configure T3 or E3 framing on an ATM interface.
Specify one of the following framing types for a T3 (DS3) interface:
cbitadm c-bit with ATM direct mapping
cbitplcp c-bit with PLCP framing (default)
m23adm M23 ATM direct mapping
m23plcp M23 with PLCP framing
Specify one of the following framing types for an E3 interface:
g832adm G.832 ATM direct mapping
g751adm G.751 ATM direct mapping
g751plcp G.751 PLCP mapping (default)
Example
host1(config-if)#atm framing g751adm
Use the no version to return framing to the default:
For a T3 interface, the default is cbitplcp
For an E3 interface, the default is g751plcp
See atm framing.
Use to enable ILMI on the interface.
Example
host1(config-if)#atm ilmi-enable
Use the no version to disable ILMI on the interface.
See atm ilmi-enable.
Chapter 1: Configuring ATM
Setting Optional Parameters
29