Platform Considerations; Module Requirements; Interface Specifiers - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

Configuration modes. This command terminates the invalid subscriber entry and
prevents additional IPCP negotiations. When IPv6CP is active and if the IPCP must
close, the router does not terminate PPP and Link Control Protocol (LCP) and does
not return the address to the pool. In this case, AAA uses the assigned IP address
and reassigns the same address when IPCP is negotiated again.

Platform Considerations

You can configure PPP interfaces on the following E Series Broadband Services
Routers:

Module Requirements

For information about the modules that support PPP interfaces on ERX14xx models,
ERX7xx models, and the ERX310 router:
For information about the modules that support PPP interfaces on the E120 and
E320 routers:

Interface Specifiers

Some of the configuration task examples in this chapter use the slot/port[.subinterface
] format to specify the physical interface on which you want to configure PPP.
However, the interface specifier format that you use depends on the router that you
are using.
For ERX7xx models, ERX14xx models, and ERX310 router, use the
slot/port[.subinterface ] format. For example, the following command specifies
E120 router
E320 router
ERX1440 router
ERX1410 router
ERX710 router
ERX705 router
ERX310 router
See ERX Module Guide, Table 1, Module Combinations for detailed module
specifications.
See ERX Module Guide, Appendix A, Module Protocol Support for information about
the modules that support PPP.
See E120 and E320 Module Guide, Table 1, Modules and IOAs for detailed module
specifications.
See E120 and E320 Module Guide, Appendix A, IOA Protocol Support for information
about the modules that support PPP.
Chapter 8: Configuring Point-to-Point Protocol
Platform Considerations
273