Enabling Multiclass Mlppp - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

can configure multiclass MLPPP on a static MLPPP interface or in a dynamic profile
for a dynamic MLPPP interface.
To configure multiclass MLPPP:
1.
2.
3.
4.
Related Topics

Enabling Multiclass MLPPP

You can enable multiclass MLPPP on an MLPPP interface and create a specified
number of multilink classes on it. A maximum number of eight multilink classes are
supported per MLPPP interface.
Before you enable multiclass MLPPP:
To enable multiclass MLPPP and create a specified number of multilink classes on a
dynamic MLPPP interface:
1.
2.
To enable multiclass MLPPP and create a specified number of multilink classes on a
static MLPPP interface:
1.
Enable multiclass MLPPP.
See "Enabling Multiclass MLPPP" on page 353.
Configure traffic classes on the multiclass MLPPP interface.
See "Configuring Traffic Classes on Multiclass MLPPP Interfaces" on page 354.
(Optional) Configure fragmentation on the multiclass MLPPP interface.
See "Configuring Fragmentation on Multiclass MLPPP Interfaces" on page 355.
(Optional) Configure reassembly on the multiclass MLPPP interface.
See "Configuring Reassembly on Multiclass MLPPP Interfaces" on page 355.
Multiclass MLPPP Overview on page 349
Example: Configuring Multiclass MLPPP on a Dynamic Interface on page 356
Example: Configuring Multiclass MLPPP on a Static Interface on page 357
Define the QoS traffic classes
See Configuring Traffic Classes That Define Service Levels.
From Global Configuration mode, create an MLPPP dynamic profile by assigning
it a name.
host1(config)#profile ppp-multilink-profile
Enable multiclass MLPPP and specify the number of multilink classes to create.
host1(config-profile)#ppp multilink multiclass multilink-classes 8
From Global Configuration mode, specify the individual interface on which you
want to configure multiclass MLPPP.
Chapter 10: Configuring Multiclass Multilink PPP
Enabling Multiclass MLPPP
353