Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 602

JUNOSe 11.1.x Link Layer Configuration Guide
ip access-routes
ip address
ip auto-configure ip-subscriber
570
Configuring a Dynamic Interface from a Profile
Use to set the maximum allowable size, in bytes, of the MTU for bridged Ethernet
interfaces.
Specify an MTU size in the range 64–9180 bytes.
Example
host1(config-profile)#bridge1483 mtu 1684
Use the no version to restore the default MTU size for bridged Ethernet interfaces,
1518 bytes.
See bridge1483 mtu.
Use to enable an access route in a profile.
Example
host1(config-profile)#ip access-routes
Use the no version to remove the access route.
See ip access-routes.
Use to assign an IP address to a profile.
Example
host1(config-profile)#ip address 192.13.5.61
Use the no version to remove the IP address assignment from the profile.
See ip address.
Use to configure a primary IP interface to enable dynamic creation of subscriber
interfaces.
Use the include-primary keyword to specify that the primary interface is assigned
to the first subscriber.
Use the exclude-primary keyword to specify that the primary interface is not
used for dynamic subscribers. By default, the primary interface is not assigned
to a dynamic subscriber.
Example
host1(config-profile)#ip auto-configure ip-subscriber include-primary
Use the no version to disable creation of dynamic subscriber interfaces associated
with this primary IP interface. Use the no version with the include-primary
keyword to specify that the primary interface is not assigned to a subscriber.