pppoe duplicate-protection
pppoe log pppoeControlPacket
pppoe mtu
pppoe mtu
Use to set up the router to offer to set up a session for the client, even if the
router has insufficient resources to establish a session.
This feature is disabled by default.
Example
host1(config-profile)#pppoe always-offer
Use the no version to disable this feature.
See pppoe always-offer.
Use to prevent a client from establishing more than one session using the same
MAC address.
This feature is disabled by default.
Example
host1(config-profile)#pppoe duplicate-protection
Use the no version to disable duplicate protection.
See pppoe duplicate-protection
Use to enable packet trace logging on PPPoE dynamic interfaces created with
this profile. Packet trace information is logged to the pppoeControlPacket log.
Example
host1(config-profile)#pppoe log pppoeControlPacket
Use the no version to turn off packet trace logging.
See pppoe log pppoeControlPacket.
Use to cause the PPPoE application to send the string to the new client created
when the profile is dynamically attached to an IP interface.
The message string is saved in nonvolatile storage (NVS).
Example
host1(config-profile)#pppoe motm string
Use the no version to disable the command.
See pppoe motm.
Chapter 17: Configuring Dynamic Interfaces
Configuring a Dynamic Interface from a Profile
589