Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 628

JUNOSe 11.1.x Link Layer Configuration Guide
profile
subscriber
596
Configuring a Dynamic Interface from a Profile
Use to configure an ATM subinterface to support a dynamic interface. Specifies
one or more types of dynamic encapsulation that the ATM 1483 subinterface
detects and accepts.
For detailed information about how to use this command, see "auto-configure"
on page 531.
Example 1 Enables autodetection for the bridged Ethernet encapsulation type
using the default lockout time range, 1–300 seconds
host1(config-subif)#auto-configure bridgedEthernet
Example 2 Enables autodetection for the bridged Ethernet encapsulation type
using a nondefault lockout time range of 3600–21600 seconds (1–6 hours)
host1(config-subif)#auto-configure bridgedEthernet lockout-time 3600 21600
Example 3 Disables encapsulation type lockout for the IP encapsulation type
host1(config-subif)#auto-configure ip lockout-time none
Example 4 Either command reenables encapsulation type lockout for the IP
encapsulation type using the default lockout time range
host1(config-subif)#auto-configure ip
host1(config-subif)#no auto-configure ip lockout-time
Example 5 Permanently locks out the PPP encapsulation type until the
auto-configure ppp command is issued
host1(config-subif)#no auto-configure ppp
Use the no version to terminate detection of the specified encapsulation type
or, if the lockout-time keyword is specified, to restore the lockout time range
to its default value, 1–300 seconds.
See auto-configure.
Use to assign a profile to a static ATM 1483 or static PPP interface. The profile
configuration is used to dynamically configure an upper bridged Ethernet, IP,
PPP, or PPPoE interface.
The default encapsulation type, any, applies to any autoconfigured encapsulation
that does not have a specific profile assignment.
Example
host1(config-subif)#profile ip holland
Use the no version to remove the profile assignment from the interface.
See profile,