Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 610

JUNOSe 11.1.x Link Layer Configuration Guide
ipv6 nd reachable-time
ipv6 nd suppress-ra
ipv6 policy
ipv6 sa-validate
578
Configuring a Dynamic Interface from a Profile
Use the no version to restore the default lifetime, 1800 seconds.
See ipv6 nd ra-lifetime.
Use to specify the amount of time, in milliseconds, that the E Series router can
reach a remote IPv6 node after some reachability confirmation event has
occurred.
Example Sets the reachable-time to 30,000 milliseconds
host1(config-profile)#ipv6 nd reachable-time 30000
Use the no version to restore the default value 0 milliseconds for router
advertisements and 3,600,000 milliseconds (1 hour) for Neighbor Discovery
activity of the E Series router.
See ipv6 nd reachable-time.
Use to suppress IPv6 router advertisement transmissions on a LAN local area
network (Ethernet) interface.
Example
host1(config-profile)#ipv6 nd suppress-ra
Use the no version to reenable the sending of IPv6 router advertisement
transmissions on the LAN (Ethernet) interface
See ipv6 nd suppress-ra.
Use to assign a policy list to the ingress or egress of an interface to which the
profile is attached.
Example
host1(config-profile)#ipv6 policy secondary-input my-policy
Use the no version to remove the association between a policy list and a profile.
See ipv6 policy
Use to enable source address validation on an IPv6 interface.
Source address validation verifies that a packet has been sent from a valid source
address.
Example
host1(config-profile)#ipv6 sa-validate