Configuring Inverse Arp For Data Pvcs - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

JUNOSe 11.1.x Link Layer Configuration Guide

Configuring Inverse ARP for Data PVCs

You can use the inarp command in ATM VC Configuration mode to enable Inverse
ARP (InARP) on a data PVC that resides on an ATM 1483 NBMA subinterface
configured with the multipoint option. The PVC must use the default encapsulation
method, aal5snap. For more information about InARP, see "Configuring an NBMA
Interface" on page 39.
For example, the following commands enable InARP with a nondefault refresh rate
(10 minutes) on a data PVC. The PVC uses aal5snap encapsulation by default. Issuing
the exit command causes the configuration to take effect.
inarp
54
Configuring Individual ATM PVC Parameters
Use to configure F5 OAM VC integrity parameters on an ATM data PVC.
You can optionally specify the following values:
upRetryCount Number of successive loopback cell responses, in the range
1–60, for the router to receive before reporting that a PVC is up; default
value is 3
downRetryCount Number of successive loopback cell responses, in the range
1–60, for the router to miss before reporting that a PVC is down; default
value is 5
retryFrequency Number of seconds, in the range 1–600, for the router to
wait between the transmission of loopback cells when it is verifying the state
of the PVC; default value is 1
To configure these VC integrity parameters, you must use the oam retry
command in ATM VC Configuration mode. There is no equivalent atm pvc
command to configure these parameters.
You must issue the exit command from ATM VC Configuration mode for the
configuration to take effect.
Example
host1(config-subif-atm-vc)#oam retry 5 6 3
host1(config-subif-atm-vc)#exit
Use the no version to restore the default values for the up retry count, down
retry count, and retry frequency parameters.
See oam retry.
host1(config)#interface atm 3/2.1 multipoint
host1(config-subif)#pvc 6 0/11
host1(config-subif-atm-vc)#inarp 10
host1(config-subif-atm-vc)#exit
host1(config-subif)#