Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 133

show atm vp
OAM alarm clear time out
OAM continuity check
Inverse ARP
See show atm vc-class.
Use to display detailed statistics for a specific ATM VP configured on the router.
Field descriptions
ServiceCategory Service type on the VP tunnel, if configured: UBR, UBR-PCR,
VBR-NRT, VBR-RT, or CBR
Peak Cell Rate Peak cell rate in kilobits per second, if a VP tunnel is
configured
Maximum VCI per VPI Maximum number of virtual circuits on each virtual
path
Current VCs Number of VCs currently configured on the router
InPackets Number of packets received
InBytes Number of bytes received
InCells Number of ATM cells received
OutPackets Number of packets transmitted
OutBytes Number of bytes transmitted
OutCells Number of ATM cells transmitted
InErrors Number of packets with errors received
OutErrors Number of packets not transmitted on this VP due to errors
InPacketDiscards Number of incoming packets discarded
InPacketUnknownProtocol Number of incoming packets with an unknown
protocol type
InByteDiscards Number of incoming bytes discarded
CrcErrors Number of CRC errors detected
SAR time-outs Number of segmentation and reassembly (SAR) timeouts
reached
Over-sized SDUs Number of oversized service data units (SDUs) received
The following fields appear only if F4 OAM is enabled on the VP:
Sending End to End Loopback Cells Enabled, Disabled
End to End OAM CC verification Enabled, Disabled
Chapter 1: Configuring ATM
:3 seconds
:disabled
:disabled
Monitoring ATM
101