Configuring Ipv4 And Ipv6 Over Static And Dynamic Pppoe; Figure 50: Ipv4 And Ipv6 Interface Columns Over Static And Dynamic - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

JUNOSe 11.1.x Link Layer Configuration Guide

Configuring IPv4 and IPv6 over Static and Dynamic PPPoE

You can configure IPv4 and IPv6 interface columns over static and dynamic PPPoE,
as shown in Figure 50 on page 538.
Figure 50: IPv4 and IPv6 Interface Columns over Static and Dynamic PPPoE
To configure IPv4 and IPv6 interface columns over dynamic PPPoE:
1.
2.
3.
4.
538
Configuring PPPoE Dynamic Interfaces over PPPoE Static Interfaces
IPv4 IPv6
Specify the loopback mode for an interface and assign both IPv6 and IPv4
addresses to the interface.
host1(config)#interface loopback 1
host1(config-if)#ipv6 address 2000::1/64
host1(config-if)#ip address 2.2.2.1/24
Create a profile that defines attributes for the dynamic interface. You can use
this profile to configure IPv4 or IPv6, or both IPv4 and IPv6 PPP interfaces.
host1(config)#profile ipv4Ipv6Profile
host1(config-profile)#ip virtual-router ppp
host1(config-profile)#ip unnumbered loopback 1
host1(config-profile)#ipv6 virtual-router ppp
host1(config-profile)#ipv6 unnumbered loopback 1
host1(config-profile)#ipv6 nd other-config-flag
host1(config-profile)#ipv6 nd ra-interval 10
host1(config-profile)#ppp authentication chap
host1(config-profile)#exit
Specify the interface.
host1(config-if)#interface gigabitEthernet 4/0/6
Set the encapsulation type to PPPoE.
IPv6 IPv4 IPv6
Gigabit Ethernet
IPv4