Figure 38: Example Of Pppoe Over Atm Stacking - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

Figure 38 on page 389 illustrates the interface stack for this configuration.

Figure 38: Example of PPPoE over ATM Stacking

atm pvc
Example
host1(config-if)#pppoe max-session-vsa override
Use the no version to restore the default behavior, ignore.
See pppoe max-session-vsa.
Use to configure a PVC on an ATM interface.
The following parameters are mandatory:
vcd Virtual circuit descriptor, which identifies a virtual circuit in the range
1–2147483647. The vcd is a unique number that you assign, which identifies
a virtual circuit. The vcd value has no relationship to the vpi and vci values
and has meaning only to the E Series router.
vpi Virtual path identifier of the PVC. The VPI is an 8-bit field in the ATM
cell header. The VPI value is unique on a single link, not throughout the ATM
network, because it has meaning only to the E Series router. The VPI value
must match the value on the switch. The parameters vpi and vci cannot be
both set to 0; if one is 0, the other cannot be 0.
vci Virtual channel identifier. The VCI is a 16-bit field in the ATM cell
header. The VCI value is unique on a single link, not throughout the ATM
network, because it has meaning only to the E Series router. The parameters
vpi and vci cannot be both set to 0; if one is 0, the other cannot be 0.
encapsulation type:
Chapter 12: Configuring Point-to-Point Protocol over Ethernet
Configuring PPPoE over ATM
389