Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 639

show columns
show pppoe interface
Example 2 Displays all reserved VC ranges on the router
host1#show atm vc reserved
Reserved VCC ranges:
Start Start End End
Interface VPI VCI
--------- ----- ----- --- ---
ATM 2/0 2 100
ATM 2/0 3 300
2 reservation(s) found
See show atm vc.
Use to display static and dynamic interface counts for each interface column.
Counts for PPP and PPPoE interface columns are updated when the PPP layer
comes up.
Counts for bridged Ethernet and IP over ATM columns are updated when the
ATM layer comes up.
Field descriptions
Type Interface type
Total Total number of interfaces on this column
Static Number of static interfaces on this column
Dynamic Number of dynamic interfaces on this column
Example
host#show columns
Interface columns:
------------------
Type
-------------------- ---------- ---------- ----------
Bridged Ethernet
IP over ATM
PPP
PPPoE
See show columns.
Use to display summary information about the encapsulation type lockout
parameters configured for PPPoE clients on a dynamic PPPoE subinterface
column.
The following field descriptions and example include only the portion of the
show pppoe interface command display relevant to lockout configuration for
PPPoE clients. For more information about using this command, see "show
pppoe interface" on page 421 in "Configuring Point-to-Point Protocol over
Ethernet" on page 375.
Monitoring Upper-Layer Dynamic Interfaces and Profiles
Chapter 17: Configuring Dynamic Interfaces
VPI VCI
2 102
3 303
Total Static Dynamic
4 2
4 2
22 12
10 5
2
2
10
5
607