Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 174

JUNOSe 11.1.x Link Layer Configuration Guide
142
Monitoring MLFR
Up Traffic can flow on the interface
Offline Traffic cannot flow because hardware is unavailable
Down Traffic cannot flow because of a problem in the interface at the
current protocol layer
LowerLayerDown Traffic cannot flow because of a problem in an
interface at a lower protocol layer
AdministrativelyDown Traffic cannot flow because of manual
administrative intervention
Number of interface down transitions Number of interfaces that have
changed to a down state
Time since last status change Time since the interface last changed its state
In bytes Number of inbound bytes received on the interface
In frames Number of inbound frames received on the interface
In errors Number of inbound errors received on the interface
In discards Number of inbound packets discarded
In unknown protos—Number of packets received on the interface with
unknown protocols
Out bytes—Number of outbound bytes transmitted on the interface
Out frames Number of outbound frames transmitted on the interface
Out errors Number of outbound errors transmitted on the interface
Out discards Number of outbound packets discarded
Example 1
host1#show frame-relay interface brief
Frame relay interface mlframe-relayTEST, status is up
Example 2
host1#show frame-relay interface mlframe-relay TEST
Frame relay interface mlframe-relayTEST, status is up
Number of interface down transitions is 0
Time since last status change 00:01:47
Number of configured circuits: 2
In bytes: 452
In frames: 19
In errors: 0
In discards: 8
In unknown protos: 0
Example 3
host1#show frame-relay interface mlframe-relay members
Frame relay interface mlframe-relay TEST is up
Out bytes: 198
Out frames: 11
Out errors: 0
Out discards: 0