Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 117

interfaceSpecifier Shows ping entries for this interface
vpi Shows details of the last ping atm command on this VPI
vci Shows details of the last ping atm command on this VCI
Field descriptions
Interface Interface number
VPI Virtual path identifier
VCI Virtual channel identifier
CellCount OAM loopback cell count configured on the interface
TimeOut Timeout configured on the interface
SentCellCount Number of loopback cells sent
RespCount Number of loopback response cells received
Status Status of the ping
Ping Cell Count Cell count configured on the circuit
Ping Time Out Timeout, in seconds, configured on the circuit
No Of Cells Sent Number of ping cells sent on this circuit
No Of Response Received Number of ping responses received on this circuit
Success Rate Percentage of successful responses received for pings sent
round-trip min/max/avg Minimum, maximum, and average time in
milliseconds that it took to receive responses to ping messages sent
Ping Status Results of the ping operation
Ping Completed Number of ping requests in the cell count were sent
Ping in Progress Ping is in operation
Ping Not Started Ping operation is not started; you may see this via
SNMP
Ping Stopped Ping operation was manually stopped
Ping Stopped OAM Down atm oam flush command was issued when
ping was enabled
ATM Interface Down Ping operation is stopped as a result of interface
down operational status
OAM Flow Type Segment, End-to-end
Example 1 Displays all entries in the router
host1#show atm ping
Interface VPI VCI CellCount TimeOut SentCellCount RespCount
Chapter 1: Configuring ATM
Status
85
Monitoring ATM