Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 625

vlan auto-configure
vlan auto-configure agent-circuit-identifier
vlan description
vlan policy
host1(config-profile)#vlan advisory-tx-speed 2000
Use the no version to restore the default behavior the Tx speed is not sent to
the LNS.
See vlan advisory-tx-speed.
Use to specify the types of dynamic upper-interface encapsulations that are
accepted or detected by a dynamic VLAN subinterface.
Include this command in the base profile for a dynamic VLAN subinterface.
Example
host1(config-profile)#vlan auto-configure ip
Use the no version to terminate detection of the specified encapsulation type.
See vlan auto-configure.
Use to create a VLAN subinterface that is based on the agent-circuit-id information
in the option 82 field of DHCP messages or in the DSL Forum VSA 26-1 of PPPoE
PADR and PADI packets.
Include this command in the base profile for a dynamic VLAN subinterface.
Example
host1(config-profile)#vlan auto-configure agent-circuit-identifier
Use the no version to disable creation of VLAN subinterfaces based on
agent-circuit-identifier information.
See vlan auto-configure agent-circuit-identifier
Use to assign a description to VLAN subinterfaces that are created with this
profile.
You can use a maximum of 64 characters for the description or to name the
alias.
Example
host1(config-profile)#vlan description test1
Use the no version to remove the VLAN description.
See vlan description.
Use to assign a VLAN policy list to an interface.
For more information about keywords, see "vlan policy" on page 679.
Chapter 17: Configuring Dynamic Interfaces
Configuring a Dynamic Interface from a Profile
593