Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 627

For example, the following commands cause the router to use ProfileB when an IPoA
packet is received, and to use ProfileA for any other received encapsulation that is
autoconfigured. When you omit the keyword, it defaults to any.
To assign a profile to an interface:
1.
2.
3.
4.
5.
atm pvc
auto-configure
host1(config-subif)#profile any ProfileA
host1(config-subif)#profile ip ProfileB
Configure a physical interface.
host1(config-if)#interface atm 2/1.10
Configure a PVC by specifying the VCD, the VPI, the VCI, and the encapsulation
type.
host1(config-subif)#atm pvc 10 100 22 aal5snap
host1(config-subif)#atm pvc 10 100 22 aal5autoconfig
Apply an existing profile.
host1(config-subif)#profile ip holland
Assign subscriber identification.
host1(config-subif)#subscriber ip user ispname domain abc.com
password 3fds9jpt
Enable the dynamic encapsulation type.
host1(config-subif)#auto-configure ip
Use to configure a PVC on an ATM interface. Select one of the following
encapsulation options:
aal5autoconfig Enables the autodetection of the 1483 encapsulation
(LLC/SNAP or VC multiplexed).
aal5snap Specifies a LLC encapsulated circuit; the LLC/SNAP header
precedes the protocol datagram.
aal5mux ip Specifies a VC multiplexed circuit. This option is used for IP
only.
Example
host1(config-subif)#atm pvc 6 0 11 aal5autoconfig
Use the no version to remove the specified PVC.
See atm pvc.
Chapter 17: Configuring Dynamic Interfaces
Configuring a Dynamic Interface from a Profile
595