Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 225

show interfaces gigabitEthernet
show interfaces tenGigabitEthernet
In: Bytes 39256, Packets 612
Multicast 0, Broadcast 0
Errors 0, Discards 0
Out: Bytes 4536220, Packets 70873
Multicast 0, Broadcast 70258
Errors 0, Discards 0
ARP Statistics:
In: ARP requests 1, ARP responses 0
Errors 0, Discards 0
Out: ARP requests 1, ARP responses 0
Errors 0, Discards 0
Example 2 Displays the status of a Fast Ethernet S-VLAN subinterface
host1:vr2#show interfaces fastEthernet 0/0.1
FastEthernet0/0.1 is Up, Administrative status is Up
SVLAN ID: 1, VLAN ID: 0, Ethertype 0x9100
In: Bytes 39256, Packets 612
Multicast 0, Broadcast 0
Errors 0, Discards 0
Out: Bytes 4536220, Packets 70873
Multicast 0, Broadcast 70258
Errors 0, Discards 0
ARP Statistics:
In: ARP requests 0, ARP responses 0
Errors 0, Discards 0
Out: ARP requests 0, ARP responses 0
Errors 0, Discards 0
See show interfaces.
Use to display the status of Gigabit Ethernet interfaces, 10-Gigabit Ethernet
interfaces, VLAN subinterfaces, or S-VLAN subinterfaces.
You can specify the following keywords:
delta Specifies that baselined statistics are to be shown
brief Displays the operational status of all configured interfaces
Field descriptions when you display the status of a Gigabit Ethernet or 10-Gigabit
Ethernet VLAN or S-VLAN subinterface
Subinterface number Location of the subinterface that carries the VLAN or
S-VLAN traffic
Administrative status Operational state that you configured for this interface;
up or down
VLAN ID Domain number of the VLAN
SVLAN ID Domain number of the stacked VLAN
Ethertype Ethertype assignment for the S-VLAN subinterface, 0x8100,
0x88a8, or 0x9100; 0x9100 is the default
Chapter 5: Configuring VLAN and S-VLAN Subinterfaces
Monitoring VLAN and S-VLAN Subinterfaces
193