Module Requirements; Interface Specifiers; Upper-Layer Protocols Over Static Ethernet References; Configuring Ip Over A Static Ethernet Interface - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

Module Requirements

For information about the modules supported on E Series routers:

Interface Specifiers

The configuration task examples in this chapter use the format for ERX7xx models,
ERX14xx models, and the ERX310 router to specify a VLAN or S-VLAN subinterface.
For ERX7xx models, ERX14xx models, and ERX310 router, use the
slot/port[.subinterface ] format. For example, the following command specifies a
VLAN subinterface configured on port 0 of an I/O module in slot 4.
For E120 and E320 routers, use the slot/adapter/port[.subinterface ] format, which
includes an identifier for the bay in which the I/O adapter (IOA) resides. For example,
the following command specifies a VLAN subinterface configured on port 0 of the
IOA installed in the upper adapter bay of slot 3.
For more information about interface types and specifiers on E Series models, see
Interface Types and Specifiers in JUNOSe Command Reference Guide.

Upper-Layer Protocols over Static Ethernet References

For more information about upper-layer protocol implementations over Ethernet,
consult the following resources:

Configuring IP over a Static Ethernet Interface

To configure IP over an Ethernet interface:
1.
Chapter 4: Configuring Upper-Layer Protocols over Static Ethernet Interfaces
See the ERX Module Guide for modules supported on ERX7xx models, ERX14xx
models, and the ERX310 router.
See the E120 and E320 Module Guide for modules supported on the E120 and
E320 routers.
host1(config)#interface fastEthernet 4/0.1
host1(config)#interface gigabitEthernet 3/0/0.1
RFC 894 A Standard for the Transmission of IP Datagrams over Ethernet
Networks (April 1984)
RFC 1042 A Standard for the Transmission of IP Datagrams over IEEE 802
Networks (February 1988)
RFC 1112 Host Extensions for IP Multicasting (August 1989)
RFC 2516 Method for Transmitting PPP over Ethernet (PPPoE) (February 1998)
Specify a Fast Ethernet, Gigabit Ethernet, or 10-Gigabit Ethernet port.
host1(config)#interface fastEthernet 4/1

Upper-Layer Protocols over Static Ethernet References

155