Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 330

JUNOSe 11.1.x Link Layer Configuration Guide
show ppp interface summary
298
Monitoring PPP Interfaces
aaa-profile
Authentication status
grant
terminate-reason
PAP protocol configuration
request-timeout
CHAP protocol configuration
name
challenge-retry
challenge-timeout
minimum-challenge-length
maximum-challenge-length
minimum-rechallenge-timeout
maximum-rechallenge-timeout
Example 3 Displays a termination reason (administrative disable) when the
operational status of the interface is down
host1#show ppp interface
PPP interface pos 0/1:1 is lowerDown
PPP interface pos 4/0:1 is lowerDown
PPP interface pos 12/1:1 is lowerDown
3 ppp interfaces found
PPP interface serial 0/0:1/1 is Up
PPP interface serial 0/0:1/2 is Down (administrative disable)
Example 4 Displays information about the PPP interface statistics for IPCP
host1#show ppp interface fastEthernet 2/0.1 statistics ip
PPP interface FastEthernet 2/0.1 is up
LCP protocol statistics
in-keepalive-requests
out-keepalive-requests
in-keepalive-replies
out-keepalive-replies
keepalive-failures
max-renegotiation-terminates
See show ppp interface.
Use to display a summary of all the multilinked and nonmultilinked PPP interfaces
configured on the router.
Field descriptions
PPP Status Nonmultilinked PPP interfaces
Configuration status Indicates the configuration state of the PPP interface,
IPCP, IPv6CP , OSINLCP, or MPLS
configured Interface or protocol is configured
notConfigured Interface or protocol is not configured
Administrative status Indicates the administrative state of the PPP interface,
IPCP, IPv6CP , OSINLCP, or MPLS
open Interface or protocol is administratively enabled
''
false
lower layer down
20 seconds
''
10
4 seconds
16
32
0 seconds
0 seconds
833
830
830
833
0
10