Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 770

JUNOSe 11.1.x Link Layer Configuration Guide
show frame-relay pvc..................................124, 140
show frame-relay subinterface....................130, 150
show frame-relay summary........................130, 150
show hdlc interface command...................................511
show interfaces commands
show interfaces fastEthernet.......................159, 190
show interfaces gigabitEthernet..................159, 190
show interfaces lag.............................................222
show interfaces lag members.............................222
show interfaces pos ...........................................371
show interfaces tenGigabitEthernet.............159, 190
show ip mac-validate command.................................463
show mpls cross-connects atm command..................105
show ppp commands
show ppp interface ............................................287
show ppp interface mlppp..................................337
show ppp interface summary.....................287, 337
show pppoe commands
show pppoe interface..........................421, 607, 701
show pppoe interface lockout-time.............608, 701
show pppoe interface summary..........................423
show pppoe subinterface....................428, 609, 702
show pppoe subinterface summary....................428
show profile commands
show profile .......................................430, 609, 703
show radius commands
show radius override..........................................433
show radius remote-circuit-id-delimiter...............434
show radius remote-circuit-id-format..................434
show subscriber-policy command..............................490
show vlan commands
show vlan bulk-config.........................................703
show vlan subinterface.......................461, 616, 710
show vlan subinterface command..............................195
shutdown command..................................................118
dynamic interfaces.....................................650, 674
Frame Relay.......................................................116
POS....................................................................368
shutting down interfaces
dynamic ATM 1483............................................650
dynamic VLAN....................................................674
Frame Relay.......................................................116
POS....................................................................368
Simple Network Management Protocol. See SNMP
link status processing
SLARP (Serial Line Address Resolution Protocol)........505
Keep-Alive protocol.............................................505
keepalive interval................................................508
overview.............................................................505
See also Cisco HDLC
slow protocols
bandwidth requirements.....................................230
definition of
rate of transmission of OAM PDUs..............230
738
Index
multicast address of
and destination MAC address of remote
entities.....................................................235
OAM messages and............................................230
SMs (Service modules)
MLPPP features...................................................308
SNAP (subnetwork attachment point)........................169
SNMP (Simple Network Management Protocol) link
status processing....................................................118
snmp trap frame-relay link-status command..............118
SONET (Synchronous Optical Network)................30, 363
source, clock
ATM interfaces......................................................28
SRP Ethernet interfaces
support for link-fault management......................242
SSN LCP (short sequence number Link Control
Protocol) configuration option................................305
stacked virtual local area networks. See S-VLANs
stateful SRP switchover
and atm atm1483 subscriber command.............636
and subscriber command...................523, 556, 561
Ethernet link-fault management
dependence on completion time.................242
effect on OAM settings................................242
of more than 2 seconds...............................242
recommendation for high and low threshold
configuration............................................242
recommendation for PDU loss threshold
setting......................................................242
static interfaces..................................................516, 623
configuring Multiclass MLPPP.............................357
creating in VC subranges............................634, 656
creating in VLAN subranges................................686
static mapping, and NBMA interfaces..........................40
subinterfaces
ATM 1483, dynamic...........................................628
ATM 1483, static.....................................................3
Frame Relay, monitoring....................................130
MLFR, monitoring...............................................150
VLAN, dynamic...................................................658
subnet mask
assigning to PPP interface...................................277
subnetwork attachment point. See SNAP
subranges, VC. See VC subranges
subscriber command.........518, 523, 556, 560, 597, 598
subscriber management, using for subscriber
authentication................................................523, 636
subscriber policies for transparent bridging...............470
configuring..........................................................480
defined...............................................................470
monitoring..........................................................490
See also subscriber policy commands
subscriber policy commands......................................490
arp......................................................................480
bridge subscriber-policy......................................480
broadcast............................................................480