Table of Contents
Advertisement
JUNOSe 11.1.x Link Layer Configuration Guide
show atm bulk-config
690
Monitoring Dynamic Interfaces and Profiles
SNMP trap link-status Whether SNMP link status traps are enabled or
disabled on the ATM AAL5 interface
Auto configure ATM 1483 status Whether the autoconfiguration feature for
a dynamic ATM 1483 subinterface configured over the ATM AAL5 interface
is enabled or disabled
InPackets Number of packets received on this interface
InBytes Number of bytes received on this interface
OutPackets Number of packets transmitted on this interface
OutBytes Number of bytes transmitted on this interface
InErrors Number of incoming errors received on this interface
OutErrors Number of outgoing errors on this interface
InPacketDiscards Number of incoming packets discarded on this interface
OutDiscards Number of outgoing packets discarded on this interface
Example
host1#show atm aal5 interface atm 3/0
AAL5 Interface ATM 3/0 operational status:
time since last status change: 00:08:46
SNMP trap link-status: disabled
Auto configure ATM 1483 status: disabled
InPackets:
0
InBytes:
0
OutPackets:
0
OutBytes:
0
InErrors:
0
OutErrors:
0
InPacketDiscards: 0
OutDiscards:
0
See show atm aal5 interface.
Use to display information, including base profile assignments and overriding
profile assignments, for the bulk-configured VC ranges on an ATM AAL5 interface.
To display information for all VC ranges on the router, use the command with
no keywords.
To display information for all VC ranges on a specified ATM AAL5 interface, use
the command with the atm keyword and interface specifier.
To display information for the VC range associated with a particular bulk
configuration name, use the command with the name keyword.
To display information for a particular VC range on a specified ATM AAL5
interface, use the command with the atm keyword and interface specifier and
the name keyword.
lowerLayerDown
Advertisement
Table of Contents
Troubleshooting
